All types of pipings, valves or pressure reducers.
After being produced, industrial gases must be available where they are intended to be used by the final user without altering its quality during the distribution.
All the components needed on an industrial piping system are proposed by GAZ SYSTÈMES. Especially all type of pipes, whether in stainless steel, copper, alumimum or steel.
GAZ SYSTÈMESprovides also the accessories such as valves, fittings, pressure reducers or terminal units. Our distribution systems might be used at low pressure below 20 bar but also up to 350 bar according to the application and the requirements of each customer.
One of the most expectation from a gas distribution system is to make sure that the gas quality will not be affected by any component during the transportation from the source up to the terminal unit. In order to make sure this will not happen, our engineering office provides studies and installation procedure so that water, dust would not degrade the quality of the gas flow.